Désolé, nous avons pas encore traduit cette page en français. Nous y travaillons.
2. Mark and cut wing

Rest the car on an axle stand and remove the road wheel. Find the midpoint between the upper and lower centre vent slot in the inner wing. Scribe a line 15/8in (41mm) above and below and on each side of this point to form a square. Cut out the square with a hacksaw. This lets the motor pass through the wing.

Il apparaît dans

Fitting an electric fan to a side radiator

Fitting an electric, thermostatically controlled fan in place of the mechanical, engine-driven t...